Cisco SCE8000 GBE - Removing and Replacing Shared Port Adapters

9-23
Cisco SCE8000 GBE Installation and Configuration Guide
OL-19897-02
Chapter 9 Removal and Replacement Procedures
Removing and Replacing Shared Port Adapters
Software revision : 1
LineCard S/N : CAT1231G03R
Power Supply type : AC
SML Application information is:
Application file: /apps/data/scos/app/en355262.sli
Application name: Engage SML Version 3.5.5 build 74
Using Lib - PL_3.5.5_b74
Using Lib - Classifier_3.5.5_b74
Application help: Entry point of Engage
Original source file:
/auto/srbu-proj1/apps/users/atukh/autoBuild/App/SML/Engage/dev/src/com/pcube/AppTemplate/M
ain/template_app_main.san
Compilation date: Tue, May 19, 2009 at 19:51:58
Compiler version: SANc v3.20 Build 12 built on: Tue 02/01/2009 11:11:05.;SME plugin v1.1
Capacity option used: 'EngageDefaultSCE8000'.
Logger status: Enabled
Platform: SCE8000
Management agent interface version: SCE Agent 3.5.5 Build 121
Software package file: Not available
SCE8000 uptime is 26 minutes, 53 seconds
After you verify installation of an SCE8000 GBE module and check connectivity, you must configure
the module. For complete information on configuring the Cisco SCE8000 GBE platform, refer to the
Cisco SCE8000 GBE Software Configuration Guide. For information on all Cisco SCE8000 GBE
platform commands, refer to the Cisco SCE8000 CLI Command Reference publication.
Removing and Replacing Shared Port Adapters
When removing and replacing the 1-port 10GBE SPAs, please follow these guidelines:
• SPAs must be installed in pairs. The Cisco SCE8000 GBE supports the following SPA
configurations:
– Two SPAs inserted in subslots 0 and 1
– Four SPAs
• If only two SPAs are installed sublots 2 and 3 must be covered by blank filler panels.
• Required Tools and Equipment, page 9-24
• Laser/LED Safety, page 9-24
• Handling SPAs, page 9-25
• SPA Installation and Removal, page 9-26
• Installing a SPA in a SIP, page 9-27
• Removing a SPA from a SIP, page 9-27