Cisco SCE8000 GBE - Page 173

A-7
Cisco SCE8000 GBE Installation and Configuration Guide
OL-19897-02
Appendix A CLI Commands to Verify a Successful Installation
Basic Post-Installation Checklist
PID: SFP-GE-S , VID: V01, SN: FNS12330A80
NAME: "SCE8000 optic 3/1/2", DESCR: "SFP-GE-S "
PID: SFP-GE-S , VID: V01, SN: FNS12330A7R
NAME: "SCE8000 optic 3/1/3", DESCR: "SFP-GE-S "
PID: SFP-GE-S , VID: V01, SN: FNS12330A92
NAME: "SCE8000 optic 3/1/4", DESCR: "SFP-GE-S "
PID: SFP-GE-S , VID: V01, SN: FNS124615JN
NAME: "SCE8000 optic 3/1/5", DESCR: "SFP-GE-S "
PID: SFP-GE-S , VID: V01, SN: FNS124615K9
NAME: "SCE8000 optic 3/1/6", DESCR: "SFP-GE-S "
PID: SFP-GE-S , VID: V01, SN: FNS124702V5
NAME: "SCE8000 optic 3/1/7", DESCR: "SFP-GE-S "
PID: SFP-GE-S , VID: V01, SN: FNS1247026J
NAME: "SCE8000 optic 3/2/0", DESCR: "XFP-10GLR-OC192SR "
PID: XFP-10GLR-OC192SR , VID: V02, SN: ONT1102108E
NAME: "SCE8000 optic 3/3/0", DESCR: "XFP-10GLR-OC192SR "
PID: XFP-10GLR-OC192SR , VID: V02, SN: ECL11030105
show interface
Run this command for each interface. The command syntax is:
show interface GigabitEthernet 3/ bay-number / port-number
sce>show interface GigabitEthernet 3/0/0
Auto negotiation configured: Disabled
Actual status:
Link is: ON
Auto negotiation: Disabled
Bandwidth (L1): 10000000 Kbps, Burst-size: 50000 bytes
Pseudo IP Address: Not Configured
show system operational status
sce>show system operation-status
System Operation status is Operational
show interface linecard
sce>show interface LineCard 0
The application assigned to slot 0 is /apps/data/scos/app/en355262.sli
Silent is off
Configured shutdown is off
Shutdown due to sm-connection-failure is off