User Guide| LQ Series 4.0
Off-Hook Tally (IVC card)
Making outgoing SIP calls from the panel
The following methods are possible:
• Speed dials
• Prepared dialing
13.8.4
Speed dials
Speed dials can be set up in the EHX software to work with a specific interface and
number. A speed dial is created and attached to a control in the EHX software, the
control is put on a key and then this key is put on a panel. To use a speed dial once
it is configured, latch the interface key and press the speed dial key (in any order).
When configuring a speed dial, the interface and the control (the number to dial)
can be stacked on the same key to reduce the number of keys used to dial a set
number. See Speed Dial and Stacked Key in the EHX User Guide.
13.8.5
Prepared dialing
When using prepared dialing, the number is dialed first (use the panel keypad or
dial menu) and the interface (panel key) is selected second. This method of dialing
Page 119
To Next Page
Loading...
Need help?
General
