User Guide| LQ Series 4.0
d. The CCM user can hang up the call by selecting the phone icon and hanging
up.
Note: SIP calls can also be hung up (ended) from the LQ device front panel menu.
Note: You can define as many SIP clients as you need, but only 8 can be registered
(connected to an LQ device) at any one time.
Note: SIP line connection status bars: green; connected, yellow; connecting, connections
pending.
Note: You will see a VOX light in the Assignments page. This lights green when audio is
coming from a port.
13.7 Program LQ-SIP and Clear-Com Eclipse
Connect a SIP telephone to your matrix.
When routing audio between LQ SIP and Eclipse, always use a Direct Channel in
the LQ CCM setup.
l The Eclipse matrix must have EHX version 9.1 or later installed
l Connect via an MVX card: connect the MVX card and the LQ unit directly using
a Cat5/6 cable
l Connect via an IVC (IP) card: LQ unit, matrix IVC card and SIP server must all
be connected to the same IP network
l The LQ unit must be connected to the same network as the SIP server. The LQ
unit must be able to see (contact) the SIP server, see your network
administrator if you have any connectivity problems.
Note: Each LQ-R unit supports up to 24 ports: 8 hardware ports, 8 SIP ports and 8 virtual
ports. Agent- IC and IVC ports are considered 'virtual ' ports. Virtual ports can be
used in any combination up to 8 in total.
Example setup:
13.7.1
General Outline
1. In the Eclipse Software, the matrix IVC port is setup as LQ SIP.
2. Create an IVC port in the LQ CCM to connect back to the Eclipse matrix IVC card.
3. The LQ unit is setup as x. 2003 on the SIP server.
4. A SIP phone is setup as x. 2005 on the SIP server.
Page 107
To Next Page
Loading...
Need help?
General
