User Guide| LQ Series 4.0
3.5.1
Link-Group Role
The Link-Master is responsible for synchronization and distribution of audio,
Channel names and device availability throughout the Link-Group. Each group
needs a Link-Master.
To create a group you must connect LQ member(s) to a Link-Master. Change this
setting to Link-Member on the device to be connected to the master. When you
change the role to Link-Member, you can then enter the Link-Master IP address
here to link the devices. Find the device IP in the front menu screen of the device.
Note: If linking with a HelixNet Main Station, the HelixNet device must always be
designated the Link-Master.
To take an LQ device out of a Link-Group, change it's role back to Link-Master here.
This will disconnect the device from the group.
Related Links
About Linking on page 58
Creating a Link-Group on page 48
3.5.2
Link-Group Optimization
Internet/NATed network (Default mode)
Use this setting whenever the network you are using crosses firewalls. This is the
default mode and will work with all networks. However, it requires more processing
power of the LQ device and may affect latency.
Page 30
To Next Page
Loading...
Need help?
General
