User Guide| LQ Series 4.0
Note: The IP address will be allocated by DHCP (default mode). In the event that the
network does not serve DHCP or there is no network connection, the IP address will
revert to a link-local address. If necessary IP addresses for the devices can be
configured in the Network page of the CCM. See information links at the bottom of
this page if you require more information.
7. Connect the audio equipment to Port A of each LQ device.
8. Once the LQ devices are set up, proceed to Creating a Link-Group on page
48.
Page 47
To Next Page
Loading...
