User Guide| LQ Series 4.0
11.1.4
Create 'virtual' ports in the CCM
Next, you need to create a port, or ports for the card. You must have to hand User
ID and Password that you entered into the EHX interface.
When the LQ is connected to the IVC-32 card, a green status LED shows. If the
connection is not successful, a yellow warning displays. Click the yellow warning
symbol for information.
11.1.5
Put new ports into a Channel.
Once ports are created, they can be seen in the Assignments page and put into
Channels.
Once a virtual port is associated to an LQ device you can adjust the port setting.
Click the cog icon to go straight to Ports page.
If you want to pass GPIO controls over the network using LQ you must program
Network Control Events. See What are Networked Control Events and how do
I use them? on page 83
Page 82
To Next Page
Loading...
Need help?
General
