Cognisys STACKSHOT 3X - Page 130

130
and to the motorized device.
Torque setting too low for
your load.
Increase the motor torque
setting. See section “9.6 -
Torque”.
Motor “squealing” when not
moving.
High Precision option is
enabled
See section “9.7 High-
Precision” for turning high
precision mode off.
Camera takes multiple
pictures per step
# pics set to greater than one
See sections “8.5 - Shutter
Output Settings” for changing
the number of pictures taken
to “1”.
Camera in continuous mode
StackShot 3X defaults to a
500ms shutter press. Make
sure the camera is in single-
shot mode otherwise you may
get more than one picture.
Need to restore factory
settings
Operator Error -- you did
something bad!
With StackShot 3X powered
off, press and hold the power
button until the red power
light goes out. Release the
power button. Optionally you
can load the defaults from the
settings page. See section
“
8.3.3 - Load Factory
Defaults”.
If you cannot resolve a problem with StackShot 3X, please contact us at
support@cognisys-
inc.com. We want to make sure that you are completely satisfied!