25
You are presented with two buttons at the bottom. If you press the “Change Start/Stop” button
you’ll be prompted for a new start and end positions. If you press the “Start” button the rail will
return to the beginning of the stack and begin the picture collection process. While the process
is running the status window will show which step is currently active and the time remaining for
the stack.
When the stack completes you’ll be given the option to change the start and end points or run
the stack again.
If you touch the screen any time during the stack it will stop the motor, abort the sequence, and
the display will show “Aborted” and give you the option to start the sequence again.
See Figure 3 below to demonstrate “Auto-Step” mode.
To Next Page
Loading...