Condair CP3 - 3.7 Options

14
3.7 Options
3.7.1 Options overview
Condair CP3 Basic... / Condair CP3 Pro...
230V1 5...8
400V3 5...8 9...15 16...45 52/60/70/80/90 105/120/135 152/160/180
230V3 5...8 9...15 16...30 44/50/60 75/90 100/120
D... Cleanable steam cylinder
Cleanable steam cylinder as an alternative
to the disposable steam cylinder built in as
standard (see also chapter 3.7.2).
P/B 1x D3.. 1x D4.. 1x D6.. 2x D6.. 3x D6.. 4x D6..
RFI
Remote operating and fault indication
PCB with relay contacts for the connection
of remote displays for “Operation”, “Steam”,
“Fault” and “Service”.
B * 1x RFI 1x RFI 1x RFI 1x RFI 1x RFI 1x RFI
OPS Overpressure set
Kit for mounting the water cup to the unit
cover when operating the steam humidi ers
in systems with a duct air pressure of up
to 10 kPa.
P/B 1x OPS 1x OPS 1x OPS 2x OPS 3x OPS 4x OPS
THV Terminals heating voltage
Separate terminals for systems where direct
connection of heating voltage to main con-
tactor (standard version) is not permitted by
local regulations.
B * 1x M-THV 1x M-THV 1x L-THV 2x L-THV 3x L-THV 4x L-THV
e-LINKS e-LINKS CP3
Gateway to connect the Condair CP3 to a
building management system. Two versions
are available: BACnet/IP or LonWorks.
P Conguration according to separate documentation
PG Cable gland P/B 1x PG 1x PG 1x PG 2x PG 3x PG 4x PG
SC.. Steam hose connector B * 1x SC22 1x SC60 1x SC80 2x SC80 3x SC80 4x SC80
SCCT.. Steam hose connector with
condensate trap
B 1x SCCT22 1x SCCT60 1x SCCT80 2x SCCT80 3x SCCT80 4x SCCT80
CT Condensate trap P/B 1x CT22 1x CT60 1x CT80 2x CT80 3x CT80 4x CT80
MP Mounting prole P/B 1x MP 1x MP 1x MP 2x MP 3x MP 4x MP
CVI Internal control voltage P/B 1x M-CVI 1x M-CVI 1x L-CVI 1x L-CVI ** 2x L-CVI 2x L-CVI
TRAFO Transformer (400V/230V) P/B 1x M-Trafo 1x M-Trafo 1x L-Trafo 1x L-Trafo ** 2x L-Trafo 2x L-Trafo
B
 UnitversionBasic
P UnitversionPro
* StandardforunitversionPro
** UnitversionBasicrequiresadditionallyoptionTHVforunitmoduleB