Condair CP3 - 6.5 Overview and operating of the menu; Menu overview

48
Demand :50%
CP3 P90 400V3
XXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXX
2014-01-21 12:00:00
Menu Set
Software :1.14LA02
CP3 P90 400V3
Controlsign.:0-10V
Limitsignal :0-10V
Modbus Addr.:1
Menu Set
Power Limit :100%
CP3 P90 400V3
Request A :50%
Request B :50%
∑ Steam :45kg/h
Menu Set
Cylindertype:A644
CP3 P90 400V3
Operating Hours
Cylinder A :22h
Cylinder B :21h
Menu Mdl B
Info
ErrorHistory:Set
Unit Status :Set
Esc Set
User CodeUser Code
88088808
Enter Number Enter Number
Confirm with Set Confirm with Set
Esc Set
UserUser
Settings :SetSettings :Set
Modbus :SetModbus :Set
Maintenance :SetMaintenance :Set
EscEsc Set
Drain Factor:1.0
CP3 P90 400V3
Conductivity:>125µS
StandbyDrain:Partial
Force Drain :On
Menu Mdl B
Timer
CP3 P90 400V3
On/Off Timer:Off
Power Limit :Off
Hum.Setpoint:Off
Menu Set
Main Menu
User :Set
Engineering :Set
Hum.Setpoint:45%rH
Info :Set
Esc Set
Main Menu
Engineering :Set
Hum.Setpoint:45%rH
Info :Set
Esc Set
User :Set
Main Menu
Hum.Setpoint:45%rH
Info :Set
Esc Set
Benutzer :Set
Engineering :Set
Main Menu
Info :Set
Esc Set
User :Set
Engineering :Set
Hum.Setpoint:45%rH
6.5 Overview and operating of the menu
The operating and display unit is operated via the four keys located
just below the display. The 4 status elds at the bottom of the display
show the active keys the functions assigned to them.
Menu overview
actual key setting
keys
Indication level
Menu level
Operating
Menu Info
– Interrogation of unit information
– Interrogation of the malfunction list
Menu User
– Resetting the maintenance counter
– Unit settings
– Modbus settings
Standby
CP3 P45 400V3
XXXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXXX
2014-01-21 12:00:00
Menu Set
Menu Engineering
The engineering level requires special knowledge and may only
be served by a Condair service technician.
Modifying humidity setpoint
Note: this menu item appears only, if the internal P/PI controller is
activated and the humidity setpoint timer is deactivated!