Condair CP3 - 6.6 Interrogation functions; 6.6.1 Interrogation of the operating information in the indication level

49
6.6 Interrogation functions
6.6.1 Interrogation of the operating information in the indication level
In the normal operating mode the operating and display unit is in the indication level. The indication
levelformsaloopthatincludesseveralpagesholdingoperatinginformationwhichcanbeaccessed
withthearrowkeys.Thevariousdisplaysoftheindicationlevelareshownbelow.
Standard operating display
Theappearanceofthestandardoperatingdisplaydependsontheactualoperatingstatusandthe
congurationoftheCondairCP3.Thefollowingdisplayarepossible.
Demand :100%
CP3 P90 400V3
Limiter : 70%
2014-01-21 12:00:00
Menu Set
Standard operating display with control via the external controller
– Standby(nohumiditydemand)orDemand%(humiditydemand
present)
– Setsupplyairlimitationin%*
*thisparameterappearsonlyifexternalsupplyairlimitationisacti-
vated
Act.Humidity: 75%rH
CP3 P90 400V3
Hum.Setpoint: 50%rH
Lim.Humidity: 60%rH
Lim.Range : 70-90%
Menu Set
Standard operating display with control via the internal controller
– Actualhumidityin%rh
– Setnominalhumidity%rh
– Setsupplyairlimitationin%**
– Setrangeforsupplyairlimitationin%**
** these parameters appear only if internal supply air limitation is
activated
Info page: Settings
Software :1.14LA02
CP3 P90 400V3
Controlsign.:0-10V
Limitsignal :0-10V
Modbus Addr.:1
Menu Set
– Softwareversion(1.14)/languageversion(LA02)
– Setcontrolsignalrange(signalY)
– Setcontrolsignalrangeforthesupplyairlimitation(signalZ).Ap-
pearsonlyifsupplyairlimitationisactivated.
– SetModbusaddressoftheunit
Info page: Performance data
Power Limit :100%
CP3 P90 400V3
Request A :50%
Request B :50%
∑ Steam :45kg/h
Menu Set
– Setpowerlimitationin%
– ActualhumiditydemandunitAin%rh
– ActualhumiditydemandunitBin%rh(ifpresent)
– Actualsteamcapacityoftheunitinkg/h
Info page: Steam cylinder type and operating hours
Cylindertype:A644
CP3 P90 400V3
Operating Hours
Cylinder A :20h
Cylinder B :20h
Menu Set
– Steam cylinder type
– OperatinghoursofthesteamcylinderAsincethelastreset.
– OperatinghoursofthesteamcylinderBsincethelastreset.
Info page: Drain settings
Drain Factor:1.0
CP3 P90 400V3
Conductivity:>125µS
StandbyDrain:Full
Forced Drain:O
Menu Set
– Setdrainfactor
– Conductivityofthewater
– Set draining type in standby operation
– Settimeintervalforforceddraining