Condair CP3 - 5.4.3 Inspecting the water installation

40
5.4.3 Inspecting the water installation
Checkthefollowingtopics:
– Water supply
 Hasltervalve(accessory“Z261”)orshut-offvalveand5µmwaterlterrespectivelybeen
installedinsupplyline?
 Haveadmissiblewaterpressure(1–10bar)andadmissibletemperature(1–40°C)been
observed?
 Doesthesupplycapacitymatchthehumidierandistheminimuminsidediameterofthesup-
plypipemaintainedthroughouttheentirelength?
Are all components and pipes properly secured and are all threaded connections securely
tightened?
 Isthewatersystemproperlysealed?
 Doesthewatersupplyinstallationmeettherequirementsofthelocalregulationsforwater
installations?
– Water drain
 Istheminimuminsidediameterofthedrainpipeof40mmmaintainedthroughouttheentire
length?
 Hasdrainpipebeeninstalledwithadownslopeofatleast10%?
 Hastheheatresistanceofthematerialusedbeenveriedtobeatleast100°C?
 Isthedrainhoseproperlysecured(hoseclampsatunitconnectiontightened)?
 Does the water drain installation meet the requirements of the local regulations for water
installations?