Conquest Imaging GE Voluson E10 - Page 35

GE Voluson E10 Training Manual
© 2017 Conquest Imaging
30
2. On the right side of the screen select Connectivity and then click
the Device Setup tab.
3. Click the WLAN Configuration button; see Figure 3-52 on page 3-59
.
4. The Wireless Network Configuration tool with available Wireless
Networks appear.
5. Select the Security tab and then click Remove.
Customizing an existing WLAN Profile
1. Press the Utilities key on the control console.
2. On the right side of the screen select Connectivity and then click
the Device Setup tab.
3. Click the WLAN Configuration button; see Figure 3-52 on page 3-59
.
4. The Wireless Network Configuration tool with available Wireless
Networks appear.
5. Select the Security tab and then click Customize.
Figure 3-56 Security - Customize
6. Customize the following information:
- Network Name (SSID)
- Check box "Connect even if Network is not Broadcasting its Name
(SSID)"
- Network Authentication (Open, Shared Key, WPA PSK or WPA2 PSK)
- Data Encryption
- Network Key
- Key Index
7. After you have filled in all the required information, click OK.