Conquest Imaging GE Voluson E10 - Page 34

GE Voluson E10 Training Manual
© 2017 Conquest Imaging
29
 Network Name (SSID)
 Check box "Connect even if Network is not Broadcasting its Name
(SSID)"
 Network Authentication (Open, Shared Key, WPA PSK or WPA2
PSK)
 Data Encryption
 Network Key
 Key Index
4. After you have filled in all the required information, click OK.
Refreshing a WLAN Network
1. Open the Wireless Network Configuration tool.
2. Click Refresh.
Setting a WLAN Network as Non-Preferable
When you make a WLAN non-preferable, you disconnect the network
from the system and delete all connection settings from the system.
Afterwards the system WILL NOT try to reconnect to this WLAN
automatically. And if you want to reconnect, you will need to re-add
this WLAN.
1. Press the Utilities key on the control console.
2. On the right side of the screen select Connectivity and then click
the Device Setup tab.
3. Click the WLAN Configuration button; see Figure 3-52 on page 3-59
.
4. The Wireless Network Configuration tool with available Wireless
Networks appear.
5. Highlight the wireless network you want to set as non-preferred.
6. Click Make Non-Preferable and confirm the message box.
Removing a WLAN Profile
1. Press the Utilities key on the control console.