Spider DSA User’s Manual
127
You can also create a new, empty window by right-clicking next to the display
window tabs, and selecting the type of window.
Figure 83: Create New Display Window by Right-clicking Top Bar
There are many different types of windows here (only some of these may be
available depending on the current test type). Right-clicking the top bar of any
window opens the window customizer dialog shown above. The other types of
windows are described here:
Empty Window: is a single frame window. Multiple signals can be overlaid in
this type of window.
Stack Window: plots each signal in a separate plot, stacked vertically. All
signals in a stacked plot must have the same x-axis quantities.
Bode Plot: plots the magnitude and phase of a signal in a stacked plot.
Waterfall Window: shows a 3D display with time on one axis, frequency on
another, and amplitude in the third.
ColorMap Window: plots frequency in the horizontal direction, time in the
vertical direction, and uses color to represent magnitude.
Numeric Window: displays numeric values of the signal in a table.
Control Composite Window: displays the test profile, control profile, alarm
and abort lines in an overlaid plot for vibration controller modes.
To Next Page
Loading...