Spider DSA User’s Manual
162
Send Socket Messages– a socket message is sent to another application. The
users must configure the socket server and client using Tools->Global Settings-
>Socket Server.
Send Digital Output Signals – a digital pulse or level is sent via Digital the I/O
port. Only one pin (of pins #05~#08) can be selected at a time. There are four
output signal patterns are available (Low-High-Low, High-Low-High). The Low
voltage is 0 V, and the High voltage is 3.3 V. When the output pattern is either
Lowe-High-Low or High-Low-High, the user can set the pulse duration by
entering the numeric value of millisecond.
Start Recording –EDM starts recording the time stream signals. The channels
to be recorded are defined under Setup->Measured Signals->Time Stream.
Stop Recording –EDM stops recording the time stream signals. Usually this
action follows a Start Recording action after certain duration of recording.
Save Signals to PC –EDM will save the signals to a file and store it on a PC’s
hard drive. Signals to be saved are defined under Setup->Measured Signals.
To Next Page
Loading...