Spider DSA User’s Manual
163
Save Signals to Internal Memory –EDM sends a command to the front-end
module to save signals to its internal memory. The signals to be saved are defined
under Setup->Measured Signals.
Reset Average –EDM resets the average.
Stop the Test –EDM stops the test.
Limit Check Off –EDM disables limit checking.
Limit Check On –EDM enables limit checking.
User Defined Events
Aside from the events generated by the control system, the user can define his/her
own events and insert them into a run schedule. These events then can then
trigger user-defined actions. Click Add a User Event to insert a new user defined
event. All available actions can be attached to this event.
To Next Page
Loading...