Spider DSA User’s Manual
20
Figure 229. Edit Model Window
To add a component, click the bottom empty line of the component table, a new
component will be added. Click any line, that component is selected. The available
coordinate systems are Cartesian, Cylindrical, and Spherical. They can be
specified per nature of each component. The X, Y and Z coordinates defines the
origin of the component center. While the XY, XZ, and YZ are the Euler angles of
the component. With these location and orientation settings, the component can
be placed at any desired location and orientation
Click the Accept button to save the changes, and this will make the other tabs
available. To remove a component, highlight the component, and click the Delete
button.
Point
Figure 230. Edit Point Window
To Next Page
Loading...