Spider DSA User’s Manual
256
Figure 169: Create New Display Window by Right-clicking Top Bar
There are 11 different types of windows here but depending on the current test
type, only some of them may be available. Right-clicking the top bar of any
window opens the window customizer dialog shown above. The other types of
windows are described here:
Empty Window: is a single frame window. Multiple signals can be overlaid in
this type of window.
Stack Window: plots each signal in a separate plot, stacked vertically. All
signals in a stacked plot must have the same x-axis quantities.
Numeric Window: displays the numeric values of the signal in a table.
Bode Plot: plots the magnitude and phase of a signal in a stacked plot.
Waterfall Window: shows a 3D display with time on one axis, frequency on
another, and amplitude in the third.
ColorMap Window: plots frequency in the horizontal direction, time in the
vertical direction, and uses color to represent magnitude.
Recording Status shows if each channel is on recording or on idle along with
the recording parameters.
To Next Page
Loading...