Spider DSA User’s Manual
27
Figure 238. Add Cube Window
The Origin of the Cube is defined by X, Y and Z coordinates, which is the center of
the Cube.
The sizes along the X, Y and Z axis are entered per cube dimensions. The unit
follows the global displacement setting of the EDM software.
The Cell counts for X, Y and Z axis are used to define the number of sections along
each direction of the cube. Note that the number of points alone each direction
will be the cell count plus 1.
Rotate values entered to XY, XZ, and YZ plane define the Euler angle of the plane.
These values need to be set per orientation of the plane under the global
coordinate system.
To Next Page
Loading...