DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
106
IGMP Snooping Static Group Settings
This table is used to configure the current IGMP snooping static group information on the Switch.
To view this window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Static Group
Settings, as shown below:
Figure 4- 47 IGMP Snooping Static Group Settings window
The following parameters can be configured:
Parameter Description
VLAN Name
The name of the VLAN for which to create IGMP snooping static group information.
VLAN List
The list of the VLAN IDs for which to create IGMP snooping static group information.
IPv4 Address
The static group address for which to create IGMP snooping static group information.
Click Apply to implement changes made. To search for an entry enter the appropriate information and click Find, to
remove and entry enter the appropriate information and click Delete.
IGMP Router Port
Users can display which of the Switch’s ports are currently configured as router ports. A router port configured by a
user (using the console or Web-based management interfaces) is displayed as a static router port, designated by S. A
router port that is dynamically configured by the Switch is designated by D, while a Forbidden port is designated by F.
To view this window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Router Port, as shown
below:
Figure 4- 48 IGMP Router Port window
Enter a VID (VLAN ID) in the field at the top of the window and click the Find button.
NOTE: The abbreviations used on this page are Static Router Port (S), Dynamic Router Port
(D) and Forbidden Router Port (F).
To Next Page
Loading...
