D-Link DGS-3700-12 - Out of Band Management Settings

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
41
Out of Band Management Settings
This window is used to configure the RJ-45 Out-of-band (OOB) management port on the Switch. The OOB port is
physically isolated from the data channels of the Switch. This port allows administrators manage the device remotely
without the impact data channel congestion. The OOB management is a method to manage devices while sharing the
network bandwidth with other management traffic. The OOB port allows Management packets and ARP requests to
pass while other packets will be dropped.
To view this window, click Management > Out of Band Management Settings, as shown below:
Figure 3- 9 Out of Band Management Settings window
The following parameters may be configured:
Parameter Description
IP Address
Enter the IP address of the interface.
Subnet Mask
Enter the Subnet mask of the interface.
Gateway
Enter the default gateway of the out of band management networks.
Status Allows the user to Enable or Disable the IP interface.
Link Status
Displays the current status of the out of band management interface.
Click Apply to implement changes.
Session Table
This window displays the management sessions since the Switch was last rebooted.
To view this window, click Management > Browse Session Table, as shown below:
Figure 3- 10 Session Table window