D-Link DGS-3700-12 - IP Interface

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
35
State To find or delete specific entries use the pull down menu to select All, Address, Static, or
Dynamic.
All – Select to view all configured neighbor devices which are IPv6 neighbors of the IP interface
previously created.
Address – Select and enter the IPv6 address of the entry you wish to find.
Static – Select to view all statically entered IPv6 neighbors on the Switch.
Dynamic – Select to view all dynamically configured neighbor devices which are IPv6 neighbors
of the IP interface previously created.
Click Add to add a new entry, click Find to search for a specific entry or click Clear to remove an entry.
IP Interface
This section includes System IP Address Settings amd Interface Settings.
System IP Address Settings
The IP address may initially be set using the console interface prior to connecting to it through the Ethernet. If the
Switch IP address has not yet been changed, read the introduction of the DGS-3700 Series CLI Manual for more
information.
To view this window, click Management > IP Interface > System IP Address Settings, as shown below:
Figure 3- 4 System IP Address Settings window
The upper part of the window allows users to manually assign the Switch's IP address, subnet mask, and default
gateway address:
1. Select Static at the top of the screen.
2. Enter the appropriate IP Address and Subnet Mask.
3. If you want to access the Switch from a different subnet from the one it is installed on, enter the IP address of
the Gateway. If you will manage the Switch from the subnet on which it is installed, you can leave the default
address (0.0.0.0) in this field.
4. If no VLANs have been previously configured on the Switch, you can use the default VLAN Name. The default
VLAN contains all of the Switch ports as members. If VLANs have been previously configured on the Switch,
you will need to enter the Management VLAN Name of the VLAN that contains the port connected to the
management station that will access the Switch. The Switch will allow management access from stations with
the same VID listed here.