DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
74
GVRP Global Settings
The GVRP allows interoperability with other switches, so the values of the GVRP timers can be configured. This table
is used to set the GVRP Global Settings.
To view this window, click L2 Features > VLAN > GVRP Global Settings as shown below:
Figure 4- 12 GVRP Timer Settings window
The following fields can be set:
Parameter Description
GVRP State
Choose Enabled to enable GVRP globally. Choose Disabled to disable GVRP globally.
Join Time
(100-100000)
The time in milliseconds that specifies the amount of time between the Switch receiving the
information about becoming a member of the group and actually joining the group. The default
is 200.
Leave Time
(100-100000)
The time in milliseconds that specifies the maximum amount of time between the Switch
receiving a leave group message from a host, and the Switch issuing a group membership
query. The default is 600. The Leave Time must be greater than 2 join times.
Leave All Time
(100-100000)
The time in milliseconds that specifies the amount of time the Switch will take to Leave All
groups. The default is 10000. The Leave All Time must be greater than the Leave Time.
NNI BPDU
Address
This specifies the GVRP’s pdu MAC address of the NNI port.
Dot1d – Specifies GVRP’s pdu MAC address of NNI port using 802.1d.
Dot1ad – Specifies GVRP’s pdu MAC address of NNI port using 802.1ad.
Click Apply to implement changes made.
GVRP Port Settings
The table allows the user to determine whether the Switch will share its VLAN configuration information with other
GARP VLAN Registration Protocol (GVRP) enabled switches. In addition, Ingress Checking can be used to limit traffic
by filtering incoming packets whose VID do not match the VLANs that the port belongs to. Results can be seen in the
table under the configuration settings, as seen below.
To view this window, click L2 Features > VLAN > GVRP Port Settings, as shown below:
To Next Page
Loading...
