D-Link DGS-3700-12 - Access Profile List

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
164
Access ID (1-128) Type in a unique identifier number for this access. This value can be set from 1 to 128.
From Use the drop-down menu to select from MAC Address, IPv4 Address, IPv6 Address, or Any.
To Use the drop-down menu to select from MAC Address, IPv4 Address, IPv6 Address, or Any.
When IPv6 is selected the user can only enter the IPv6 source address or the IPv6
destination address at any one time.
Action
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile to be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the config mirror port command. Port Mirroring must be enabled and a target port
must be set.
Option Use the pull-down menu to select an option, the user can choose among Change 1P
Priority, Replace DSCP, and Replace ToS Precedence.
Apply To Use the pull-down menu to select an option, the user can choose among Ports, VLAN Name
or VLAN ID and enter the appropriate information.
Click Apply to implement changes made.
Access Profile List
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the
Switch will examine, such as the MAC source address or the IP destination address. The second part is entering the
criteria the Switch will use to determine what to do with the frame. The entire process is described below in two parts.
To view this window, click ACL > Access Profile List, as shown below:
Figure 7- 2 Access Profile List window
To add an ACL Profile, click the Add ACL Profile button, which, will display the window below. There are four Access
Profile Configuration windows; one for Ethernet (or MAC address-based) profile configuration, one for IPv4 address-
based profile configuration, one for the Packet Content and one for IPv6. Explore the four Access Profile Configuration
options by entering a Profile ID and Profile Name and using the radio button to select an ACL Type and click Select.
The user may remove all Access Profiles by clicking the Delete All button (This button will not clear Address Binding
ACL entries, which can only be deleted through the IP-MAC Binding window). The window shown below is for
Ethernet.