DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
120
Figure 4- 71 MLD Snooping Multicast VLAN Settings (Edit) window
The following fields can be set:
Parameter Description
State Toggle the State between Disabled and Enabled.
Replace Source IP
Enter the IP address to replace the source IP address.
Remap Priority Use the drop-down menu to select a remap priority value between 0 and 7, or select None.
Alternatively, tick the Replace Priority check box.
Untagged Member
Ports
Tick the desired untagged member ports, or click either Select All or Clear All.
Tagged Member
Ports
Tick the desired tagged member ports, or click either Select All or Clear All.
Untagged Source
ports
Tick the desired untagged source ports, or click either Select All or Clear All.
Tagged Source
Ports
Tick the desired tagged source ports, or click either Select All or Clear All.
Click Apply to implement changes made.
Multicast Filtering
The Multicast Filtering section includes IPv4 Multicast Filtering and IPv6 Multicast Filtering.
IPv4 Multicast Filtering
The IPv4 Multicast Filtering section includes IPv4 Multicast Profile Settings, IPv4 Limited Multicast Range Settings,
and IPv4 Max Multicast Group Settings.
IPv4 Multicast Profile Settings
This window allows the user to add a profile to which multicast IPv4 address(es) reports are to be received on
specified ports or VLANs on the Switch. This function will therefore limit the number of reports received and the
number of multicast groups configured on the Switch. The user may set an IP Multicast address or range of IPv4
multicast addresses to accept reports (Permit) or deny reports (Deny) coming into the specified switch ports or
VLANs.
To view this window, click L2 Features > Multicast Filtering > IPv4 Multicast Filtering > IPv4 Multicast Profile
Settings, as shown below:
To Next Page
Loading...
