DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
201
This window allows you to set the following features:
Parameter Description
Authentication
Mode
The Authentication Mode allows the user to choose among, Disabled, Port Based or MAC
Based Authentication Mode. When choosing MAC Based, Host-based Network Access Control
will be enabled on the port.
Authentication
Protocol
Choose the Authentication Protocol either RADIUS EAP or Local.
Forward EAPOL
PDU
This indicates if the Switch forward EAPOL PDU packet, when 802.1X state is globally disabled.
Max User
(1-1536)
Specify the maximum number of users that can be authenticated via 802.1X authentication.
RADIUS
Authentication
Choose Enabled to enable RADIUS Authentication or Disabled
authentication.
Click Apply to implement your configuration changes.
802.1X Port Settings
This window is used to configure the 802.1X Port Settings.
To view this window, click Security > 802.1X > 802.1X Port Settings as shown below:
Figure 8- 10 802.1X Port Settings window
This window allows you to set the following features:
Parameter Description
From Port /To Port
Enter the port or ports to be set.
QuietPeriod
(0-65535)
This allows you to set the number of seconds that the Switch remains in the quiet state
following a failed authentication exchange with the client. The default setting is 60 seconds.
To Next Page
Loading...
