DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
305
Configuration File Backup & Restore
The Switch supports dual image storage for configuration file backup and restoration. The firmware and configuration
images are indexed by ID number 1 or 2. To change the boot firmware image, use the Configuration ID drop-down
menu to select the desired configuration file to backup or restore. The default Switch settings will use image ID 1 as
the boot configuration or firmware.
To view this window, click Tools > Configuration File Backup & Restore, as shown below:
Figure 12- 5 Configuration File Backup & Restore window
To restore the configuration file to a TFTP server, enter the TFTP Server IP address (either IPv4 or IPv6), file/path
name, select the desired Configuration ID, and then click Restore.
To backup the configuration file to a TFTP server, enter the TFTP Server IP address (either IPv4 or IPv6), file/path
name, select the desired Configuration ID, and then click Backup.
To restore the configuration file to HTTP, use the Browse button and select a Source File, select the desired
Configuration ID, and then click Restore.
To backup the configuration file to HTTP, use the Browse button and select a Source File, select the desired
Configuration ID, and then click Backup.
To Next Page
Loading...
