D-Link DGS-3700-12 - CFM Port Settings

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
274
The fields that can be configured are described below:
Parameter Description
State Tick the check box to toggle between Enabled and Disabled.
Enabled – The CFM Extension LCK setting state is Enabled.
Disabled – The CFM Extension LCK setting state is Disabled. This is the default value.
Period Tick this check box to toggle between 1sec and 1min.
Level Tick this check box and select the level between 0 and 7.
Click Apply to implement changes made.
CFM Port Settings
This table is used to enable or disable the connectivity fault management function on a per port basis. CFM is disabled
on all ports by default.
To view this window, click OAM > CFM > CFM Port Settings, as shown below:
Figure 10- 9 CFM Port Settings window
Enter the port list you wish to Enable and click Apply.
The fields that can be configured are described below:
Parameter Description
From Port/To Port
To select the port range used for this configuration.
State
To enable or disable the state of specific port regarding the CFM configuration. The default
State is Disabled.
Click Apply to implement changes made.