DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
273
Xcon CCM - Only the fault alarms whose priority is equal to or higher than “Cross-connect
CCM Received” are sent.
None - No fault alarm is sent. This is the default value.
MEP State
This is the MEP administrative state.
Enabled - MEP is enabled.
Disabled - MEP is disabled. This is the default value.
PDU Priority
The 802.1p priority is set in the CCM and the LTM messages transmitted by the MEP. The
range is 0 to 7. The default value is 7.
Alarm Time (250-
1000)
This is the time that a defect must exceed before the fault alarm can be sent. The unit is in
centiseconds. The range is 250 to 1000. The default value is 250.
Alarm Reset Time
(250-1000)
This is the dormant duration time before a defect is triggered before the fault can be re-
alarmed. The unit is in centiseconds. The range is 250 to 1000. The default value is 1000.
Click Apply to implement changes made.
To view the CFM Extension AIS Settings window, click the Edit AIS button on the CFM MEP Information window.
The following window opens:
Figure 10- 7 CFM Extension AIS Settings window
The fields that can be configured are described below:
Parameter Description
State Tick the check box to toggle between Enabled and Disabled.
Enabled – The CFM Extension AIS setting state is Enabled.
Disabled – The CFM Extension AIS setting state is Disabled. This is the default value.
Period Tick this check box to toggle between 1sec and 1min.
Level Tick this check box and select the level between 0 and 7.
Click Apply to implement changes made.
To view the CFM Extension LCK Settings window, click the Edit LCK button on the CFM MEP Information window.
The following window opens:
Figure 10- 8 CFM Extension LCK Settings window
To Next Page
Loading...
