DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
272
Figure 10- 5 CFM MEP Information window
To re-configure the MEP entry, click on the Edit button.
Figure 10- 6 CFM MEP Information (Edit) window
The fields that can be configured are described below:
Parameter Description
CCM State
This is the CCM transmission state.
Enabled – The CCM transmission state is enabled.
Disabled – The CCM transmission state is disabled. This is the default value.
Fault Alarm
This is the control types of the fault alarms sent by the MEP.
All - All types of fault alarms will be sent.
MAC Status - Only the fault alarms whose priority is equal to or higher than “Some Remote
MEP MAC Status Error” are sent.
Remote CCM - Only the fault alarms whose priority is equal to or higher than “Some Remote
MEP Down” are sent.
Errors CCM - Only the fault alarms whose priority is equal to or higher than “Error CCM
Received” are sent.
To Next Page
Loading...
