D-Link DGS-3700-12 - ARP Table

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
34
MAC Address
The MAC address of the ARP entry.
After entering the IP Address and MAC Address of the Static ARP entry, click Apply to implement the new entry. To
completely clear the Static ARP Settings, click the Delete All button.
NOTE: The Switch supports up to 255 static ARP entries.
ARP Table
This window displays current ARP entries on the Switch. To search a specific ARP entry, enter an Interface Name or
an IP Address at the top of the window and click Find. Click the Show Static button to display static ARP table
entries. To clear the ARP Table, click Clear All.
To view this window, click Manamgement > ARP > ARP Table, as shown below:
Figure 3- 2 Browse ARP Table window
IPv6 Neighbor Settings
This window allows the user to create and configure IPv6 Neighbor settings on the Switch. The Switch’s current IPv6
neighbor settings will be displayed in the table at the bottom of this window.
To view this window, click Management > IPv6 Neighbor Settings as shown below:
Figure 3- 3 IPv6 Neighbor Settings window
The following parameters can be configured:
Parameter Description
Interface Name
Enter the interface name of the IPv6 neighbor you wish to configure.
Neighbor IPv6
Address
Enter the neighbor IPv6 address of the entry you wish to configure.
Link Layer MAC
Address
Enter the MAC address of the neighbor device to be added as an IPv6 neighbor on the IP
interface.
Interface Name
In order to search for a previously configured Interface name enter the appropriate information
and click Find. To remove a previously configured Interface enter the Interface name and click
Clear.