D-Link DGS-3700-12 - DDM Status Table

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
22
From Port /To Port
Specifies a port or range of ports to be configured.
High Alarm
This is the highest threshold for the alarm. When the operating parameter rises above this
value, action associated with the alarm will be taken.
Low Alarm
This is the lowest threshold for the alarm. When the operating parameter falls below this value,
action associated with the alarm will be taken.
High Warning
This is the highest threshold for the warning. When the operating parameter rises above this
value, action associated with the warning will be taken.
Low Warning
This is the lowest threshold for the warning. When the operating parameter falls below this
value, action associated with the warning will be taken.
Click Apply to implement changes made.
DDM Status Table
This window displays the current operating digital diagnostic monitoring parameters and their values on the SFP
module for specified ports.
To view this window, click System Configuration > Port Configuration > DDM > DDM Status Table, as shown
below:
Figure 2- 11 Browse DDM Status List window
To view the status for a specific port or list of ports, enter the port list and click Find. To display the status for all ports,
tick the All Ports check box and click Find.
Port Settings
To view this window, click System Configuration > Port Configuration > Port Settings, as shown below:
To configure switch ports:
Choose the port or sequential range of ports using the From Port / To Port port pull-down menus.