DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
298
Figure 11- 21 RSPAN Settings window (Modify)
Enter the Source Ports or Redirect Ports you wish to Add or Delete and click Apply. To return to the RSPAN Settings
window click <<Back.
sFlow
The sFlow folder contains four windows to enable and configure the sFlow settings on the Switch.
sFlow Global Settings
This table is used to enable or disable the sFlow Global State Settings on the Switch. The sFlow version, address and
state configurations can also be viewed in this table.
To view this window, click Monitoring > sFlow > sFlow Global Settings, as shown below:
Figure 11- 22 sFlow Global Settings window
Select Disabled or Enabled and click Apply.
sFlow Analyzer Server Settings
This window is used to configure the sFlow analyzer server settings. Users can specify more than one analyzer server
with the same IP address but with different UDP port numbers. Users can have up to four unique combinations of IP
address and UDP port numbers.
To view this window, click Monitoring > sFlow > sFlow Analyzer Server Settings, as shown below:
Figure 11- 23 sFlow Analyzer Server Settings window
The following parameters can be configured:
Parameter Description
To Next Page
Loading...
