D-Link DGS-3700-12 - Ipv4 Route Table

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
144
IPv4 Route Table
On this window the user can view the Static IPv4 entries configured.
To view this window, click L3 Features > IPv4 Route Table, as shown below:
Figure 5- 2 IPv4 Route Table window
IPv6 Static/Default Route Settings
A static entry of an IPv6 address can be entered into the Switch’s routing table for IPv6 formatted addresses.
To view this window, click L3 Features > IPv6 Static/Default Route Settings, as shown below:
Figure 5- 3 IPv6 Static/Default Route Settings window
The fields that can be configured are described below:
Parameter Description
IPv6 Address/Prefix
Length
The IPv6 address and corresponding Prefix Length of the IPv6 static route entry. To use the
default route for this configuration, tick the Default option.
Interface Name
The IP Interface where the static IPv6 route is created.
Nexthop Address
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
Metric
The metric of the IPv6 interface entered into the table representing the number of routers
between the Switch and the IPv6 address above. Metric values allowed are between 1 and
65535.
Backup State
This field will indicate the role of this interface for the IPv6 network connection for the switch,
whether Primary or Secondary.
Click Apply to implement changes made.