D-Link DGS-3700-12 - Dhcpv6 Relay Settings

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
261
Parameter Description
DHCPv6 Relay State Enable DHCPv6 relay or disable DHCPv6 relay globally on the Switch. Click Apply to
change the DHCPv6 relay status.
DHCPv6 Relay Hop
Count (1-32)
Set the number of hops allowed for DHCPv6 relay. The default value is 4.
DHCPv6 Relay Settings
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Settings, as shown
below:
Figure 9- 16 DHCPv6 Relay Settings window
The following parameters may be configured.
Parameter Description
DHCPv6 Relay State
Settings
Enter a valid Interface Name, choose to enable or disable DHCPv6 relay status for the
interfaces and click the Apply button to put the settings into effect. To apply to all interfaces
(optional), click the All option box.
Add DHCPv6 Server
Address
Enter a valid Interface Name and DHCPv6 Server Address and click Add to ad the server to
the list of available DHCPv6 servers. To view existing configurations for a specific Interface
Name, enter the name and click on Find.
Click the Show Detail link to view the Interface Name and Server Address of existing entries.