D-Link DGS-3700-12 - IGMP Snooping Multicast VLAN Settings

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
117
Figure 4- 65 Multicast Group Profile Multicast Address Settings window
Enter the Multicast Address List and click Add the new information will be displayed in the table. Click <<Back to
return to the IGMP Multicast Group Profile Settings window and click Delete to remove an entry.
IGMP Snooping Multicast VLAN Settings
This window is used to configure the IGMP Snooping Multicast VLAN settings on the Switch.
To view this window, click L2 Features > L2 Multicast Control > Multicast VLAN > IGMP Snooping Multicast
VLAN Settings, as shown below:
Figure 4- 66 IGMP Snooping Multicast VLAN Settings window
The following fields can be set:
Parameter Description
IGMP Multicast
VLAN State
Enable or disable the IGMP multicast VLAN state. Click Apply to let the change take effect.
IGMP Multicast
VLAN Forward
Unmatched
Enable or disable IGMP multicast VLAN forward unmatched. Click Apply to let the change
take effect.
VLAN Name
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user wishes to
modify the IGMP Snooping Settings for.
VID (2-4094)
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user wishes to
modify the IGMP Snooping Settings for.
Remap Priority
Choose the level, if any, to remap the 802.1p user priority value entered in the Priority field
before forwarding it.
Replace Priority
Tick the check box to enable this option used to re-write the 802.1p user priority value entered
in the Priority field before forwarding it. Otherwise, a packet will have its incoming 802.1p user
priority re-written to its original value before being forwarded by the Switch.
To modify an entry, click the corresponding Modify. To delete an entry, click the corresponding Delete button.
To edit an entry, click the corresponding Edit button. The following window appears: