DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
121
Figure 4- 72 IPv4 Multicast Profile Settings window
The following fields can be set
Parameter Description
Profile ID (1-60) Enter a Profile ID between 1 and 60.
Profile Name
Enter a name for the IPv4 Multicast Profile.
To delete all the entries, click the Delete All button. To edit an entry, click the corresponding Edit button, as shown
below:
Figure 4- 73 IPv4 Multicast Profile Settings (Edit) window
To configure the Group List Settings click the hyperlinked Group List.
Figure 4- 74 IP Multicast Address Group List Settings window
Enter the multicast Address List, starting with the lowest in the range, and then click Add. To return to the IPv4
Multicast Profile Settings window, click the <<Back button.
IPv4 Limited Multicast Range Settings
This window enables the user to configure the ports or VLANs on the switch that will be involved in the Limited IPv4
Multicast Range. The user can configure the range of IPv4 multicast addresses that will be accepted on the ports or
VLANs.
To configure these settings, click L2 Features > Multicast Filtering > IPv4 Multicast Filtering > IPv4 Limited
Multicast Range Settings. The following window will open:
To Next Page
Loading...
