D-Link DGS-3700-12 - MLD Host Table

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
116
Port List
The Port List of the multicast group.
Click Apply to implement changes made.
MLD Host Table
This window allows users to display the current host of the VLAN, port or group on the Switch. The hosts only take
effect when fast leave is enabled. If no parameter is specified, it will display all hosts in the Switch.
To view this window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Host Table, as shown
below.
Figure 4- 63 MLD Host Table window
The following parameters may be viewed or modified:
Parameter Description
VLAN Name
The VLAN name of the host information to be displayed.
VID List
The VID List of the host information to be displayed.
Port List
The port range of the host information to be displayed.
Group Address
The group IPv6 address of the host information to be displayed.
Multicast VLAN
The Multicast VLAN section includes IGMP Multicast Group Profile Settings, IGMP Snooping Multicast VLAN Settings,
MLD Multicast Group Profile Settings, and MLD Snooping Multicast VLAN Settings.
IGMP Multicast Group Profile Settings
This table allows the user to create igmp multicast group profiles and specify multicast address lists on the Switch.
To view this window, click L2 Features > L2 Multicast Control > Multicast VLAN > IGMP Multicast Group Profile
Settings, as shown below:
Figure 4- 64 IGMP Multicast Group Profile Settings window
To configure the multicast address list once a profile has been created, click on the hyperlinked
Group List to reveal
the following window: