D-Link DGS-3700-12 - RADIUS Accounting Settings

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
205
Parameter Description
Index Choose the desired RADIUS server to configure: 1, 2 or 3.
IPv4 Address/IPv6
Address
Select either IPv4 Address or IPv6 Address to set the RADIUS Server IP.
Authentication Port
(1-65535)
Set the RADIUS authentication server(s) UDP port. The default port is 1812.
Accounting Port
(1-65535)
Set the RADIUS account server(s) UDP port. The default port is 1813.
Timeout (1-255) Enter the timeout value in seconds (1 to 255) the default value is 5.
Retransmit (1-255) Set the retransmit value in seconds (1 to 255) the default value is 2.
Key
(Max:32 characters)
Set the key the same as that of the RADIUS server. Maximum length of the entry is 32
bytes.
Confirm Key Re-enter the previously entered Key.
Click Apply to implement changes.
RADIUS Accounting Settings
The Accounting feature of the Switch uses a remote RADIUS server to collect information regarding events occurring
on the Switch. The following is a list of information that will be sent to the RADIUS server when an event triggers the
Switch to send these informational packets.
• Account Session ID
• Account Status Type
• Account Terminate Cause
• Account Authentication
• Account Delay Time
• Account Session Time
• Username
• Service Type
• NAS IP Address
• NAS Identifier
• Calling Station ID
There are three types of Accounting that can be enabled on the Switch.
• Network – When enabled, the Switch will send informational packets to a remote RADIUS server when
network events occur on the Switch.
• Shell – When enabled, the Switch will send informational packets to a remote RADIUS server when a user
either logs in, logs out or times out on the Switch, using the console, Telnet, or SSH.
• System - When enabled, the Switch will send informational packets to a remote RADIUS server when system
events occur on the Switch, such as a system reset or system boot.
Remember, this feature will not work properly unless a RADIUS Server has first been configured. This RADIUS server
will format, store and manage the information collected here.
To view this window, click Security > RADIUS > RADIUS Accounting Settings, as shown below: