DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
77
Figure 4- 16 Subnet VLAN Settings window
The following parameters can be configured:
Parameter Description
VLAN Name
The VLAN Name to be associated with the subnet.
VID
The VLAN ID to be associated with the subnet.
IPv4 Network
Address
Is used to specify an IPv4 network address. The format is ipaddress/prefix length. The prefix
length of the IPv4 network address cannot be greater than 64.
IPv6 Network
Address
Is used to specify an IPv6 network address. The format is ipaddress/prefix length. The prefix
length of the IPv6 network address cannot be greater than 64.
Priority
The priority to be associated with the subnet. Its range is 0 to 7.
Enter the appropriate information and click Add to create a new entry. To search for a particular entry enter the
appropriate information and click Find. To remove an entry click Delete. To view all entries on the Switch, click Show
All. To remove all entries, click Delete All.
VLAN Precedence Settings
The VLAN precedence settings are used to configure VLAN classification precedence on each port. You can specify
the order of MAC-based VLAN classifications and subnet VLAN classifications. If a port’s VLAN classificataion is a
MAC-based precedence, MAC-based VLAN classification will process first. If MAC-based VLAN classification fails, the
subnet VLAN classification will be executed. If a port’s VLAN classification is subnet VLAN precedence, the subnet
VLAN classification will process first. If subnet VLAN classification fails, the MAC-based VLAN classification will be
executed.
To view this window, click L2 Features > VLAN > Subnet VLAN > VLAN Precedence Settings, as shown below:
To Next Page
Loading...
