D-Link DGS-3700-12 - Jumbo Frame Settings

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
25
Parameter Description
Port
Displays the port that has been error disabled.
Port State Describes the current running state of the port, whether Enabled or Disabled.
Connection Status
This field will read the uplink status of the individual ports, whether enabled or Disabled.
Reason
Describes the reason why the port has been error-disabled, such as a STP loopback
occurrence.
Jumbo Frame Settings
This window will enable or disable the Jumbo Frame function on the Switch. The default is Disabled. When enabled,
jumbo frame (frames larger than the standard Ethernet frame size of 1536 bytes) of up to 13K (and 13312 bytes
tagged) can be transmitted by the Switch.
To view this window, click System Configuration > Port Configuration > Jumbo Frame Settings, as shown below:
Figure 2- 15 Jumbo Frame window
Click Apply to implement changes made.
Serial Port Settings
The following window contains information about the Serial Port Settings including the Baud Rate and the Auto Logout
settings.
To view this window, click System Configuration > Serial Port Settings, as shown below:
Figure 2- 16 Serial Port Settings window
The fields that can be configured are described below:
Parameter Description
Baud Rate
This field specifies the baud rate for the serial port on the Switch. There are four possible
baud rates to choose from, 9600, 19200, 38400 and 115200. For a connection to the Switch
using the CLI interface, the baud rate must be set to 115200, which is the default setting.
Auto Logout
Select the logout time used for the console interface. This automatically logs the user out after
an idle period of time, as defined. Choose from the following options: 2 Minutes, 5 Minutes, 10
Minutes, 15 Minutes or Never. The default setting is 10 minutes.
Click Apply to implement changes made.