DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
119
Figure 4- 69 Multicast Group Profile Multicast Address Settings window
Enter the Multicast Address List and click Add the new information will be displayed in the table. Click <<Back to
return to the MLD Multicast Group Profile Settings window and click Delete to remove an entry.
MLD Snooping Multicast VLAN Settings
This window is used to configure the MLD Snooping Multicast VLAN settings on the Switch.
To view this window, click L2 Features > L2 Multicast Control > Multicast VLAN > MLD Snooping Multicast VLAN
Settings, as shown below:
Figure 4- 70 MLD Snooping Multicast VLAN Settings window
The following fields can be set:
Parameter Description
MLD Multicast
VLAN State
Choose Enabled to enable or Disabled to disable the MLD Multicast VLAN on the Switch. This
is disabled by default. Click the Apply button to make the change.
MLD Multicast
VLAN Forward
Unmatched
Choose Enabled to enable or Disabled to disable forwarding of unmatched packets, that is,
packets that do not match a valid destination address of the MLD VLAN. This is disabled by
default. Click the Apply button to make the change.
VLAN Name
This is the VLAN Name that, along with the VLAN ID, identifies the MLD VLAN being added.
VID (2-4094)
This is the VLAN ID that, along with the VLAN Name, identifies the MLD VLAN being added.
Remap Priority
Choose the level, if any, to remap the 802.1p user priority value entered in the Priority field
before forwarding it.
Replace Priority
Tick the check box to enable this option used to re-write the 802.1p user priority value entered
in the Priority field before forwarding it. Otherwise, a packet will have its incoming 802.1p user
priority re-written to its original value before being forwarded by the Switch.
To modify an entry, click the corresponding Modify. To delete an entry, click the corresponding Delete button.
To edit an entry, click the corresponding Edit button. The following window appears:
To Next Page
Loading...
