DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
285
Figure 11- 5 Received (RX) Table window (for Bytes and Packets)
The following fields may be set or viewed:
Parameter Description
Port
Use the drop-down menu to choose the port that will display statistics.
Time Interval Select the desired setting between 1s and 60s, where "s" stands for seconds. The default
value is one second.
Record Number Select number of times the Switch will be polled between 20 and 200. The default value is
200.
Bytes
Count the number of bytes received on the port.
Packets
Count the number of packets received on the port.
Unicast
Count the total number of good packets that were received by a unicast address.
Multicast
Count the total number of good packets that were received by a multicast address.
Broadcast
Count the total number of good packets that were received by a broadcast address.
Show/Hide
Check whether to display Bytes and Packets.
Clear
Clicking this button clears all statistics counters on this window.
Clicking this button instructs the Switch to display a table rather than a line graph. View Table
Clicking this button instructs the Switch to display a line graph rather than a table. View Graphic
UMB_cast (RX)
This table displays the UMB_cast RX Packets on the Switch. To select a port to view these statistics or, select the port
by using the Port pull-down menu. The user may also use the real-time graphic of the Switch at the top of the web
page by simply clicking on a port.
To view this window, click Monitoring > Statistics > Port Statistics > Packets > UMB_cast (RX), as shown below:
To Next Page
Loading...
