DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
20
Figure 2- 7 DDM Voltage Threshold Settings window
The following fields can be configured:
Parameter Description
From Port / To Port
Specifies a port or range of ports to be configured.
High Alarm
This is the highest threshold for the alarm. When the operating parameter rises above this
value, action associated with the alarm will be taken.
Low Alarm
This is the lowest threshold for the alarm. When the operating parameter falls below this value,
action associated with the alarm will be taken.
High Warning
This is the highest threshold for the warning. When the operating parameter rises above this
value, action associated with the warning will be taken.
Low Warning
This is the lowest threshold for the warning. When the operating parameter falls below this
value, action associated with the warning will be taken.
Click Apply to implement changes made.
DDM Bias Current Threshold Settings
This table is used to configure the threshold of the bias current for specific ports on the Switch.
To view this window, click System Configuration > Port Configuration > DDM > DDM Bias Current Threshold
Settings, as shown below:
Figure 2- 8 DDM Bias Current Threshold Settings window
The following fields can be configured:
Parameter Description
From Port /To Port
Specifies a port or range of ports to be configured.
High Alarm
This is the highest threshold for the alarm. When the operating parameter rises above this
value, action associated with the alarm will be taken.
Low Alarm
This is the lowest threshold for the alarm. When the operating parameter falls below this value,
action associated with the alarm will be taken.
High Warning
This is the highest threshold for the warning. When the operating parameter rises above this
value, action associated with the warning will be taken.
Low Warning
This is the lowest threshold for the warning. When the operating parameter falls below this
value, action associated with the warning will be taken.
To Next Page
Loading...
