DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
185
IPv6 Address
IPv6 Source Address – Enter an IPv6 address to be used as the source address mask.
IPv6 Destination Address – Enter an IPv6 address that will be used as the destination
address mask.
NOTE: At any one time the user can only choose IPv6 class and
IPv6 Flow Label together or IPv6 Address by itself.
Click Create to set this entry in the Switch’s memory.
To view the settings of a previously correctly created profile, click the corresponding Show Details button on the CPU
Access Profile List window. The following window opens:
Figure 7- 35 CPU Access Profile Detail Information window (IPv6)
The window shown below is the Add CPU ACL Profile window for Packet Content:
Figure 7- 36 Add CPU ACL Profile window (Packet Content)
The following parameters may be configured for the Packet Content filter.
Parameter Description
Profile ID This value can be set from 1 to 5.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or packet content
To Next Page
Loading...
