D-Link DGS-3700-12 - Page 41

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
39
255.255.255.0 for a Class C network, but custom subnet masks are allowed.
VLAN Name
This allows the entry of a VLAN Name from which a management station will be allowed to
manage the Switch using TCP/IP (in-band via web manager or Telnet). Management stations that
are on VLANs other than the one entered here will not be able to manage the Switch in-band
unless their IP addresses are entered in the Security IP Management window. If VLANs have
not yet been configured for the Switch, the default VLAN contains all of the Switch's ports. There
are no entries in the Security IP Management table, by default, so any management station that
can connect to the Switch can access the Switch until a management VLAN is specified or
Management Station IP Addresses are assigned.
IPv4 State Toggle between Enabled and Disabled. The default is Enabled.
Interface Admin
State
Toggle between Enabled and Disabled. This must be set to Enabled when setting an IP address
on this window.
Click Apply to allow changes to take effect.
To view this window, click Management > IP Interface > Interface Settings > IPv6 Edit, as shown below:
Figure 3- 7 IPv6 Interface Settings (Edit IPv6) window
To configure IPv6 interface settings, enter an IPv6 Address and click Apply. The new entry will appear in the table at
the bottom of the window.
After making the desired changes, click the Apply button. The following parameters may be configured or viewed:
Parameter Description
Interface Name
The name of the IPv6 interface being displayed or modified.
IPv6 State Choose Enabled to enable IPv6 address function or choose Disabled to disable IPv6 function.
Interface Admin
State
Toggle between Enabled and Disabled. This must be set to Enabled when setting an IP address on
this window.
IPv6 Network
Address
Enter the IPv6 address of the interface to be modified.
DHCPv6 Client Toggle between Enabled and Disabled to determine the DHCPv6 client status of the interface.
NS Retransmit
Time
(0-4294967295)
Enter a value between 0 and 4294967295. This is the neighbor solicitation’s retransmit timer in
milliseconds. The default is zero.
Automatic Link
Toggle between Enabled and Disabled. Enabling this is helpful when no external source of network