Daikin Myzone 3 - Myzone Wiring Connections to Braemar and Gree Units

29
Connection
1. Connect the Manufacturers wired controller to the Indoor
Unit CB.
2. Enter the service mode parameters (see page 30).
3. As per the instructions below set the sensor to return air for
all modes.
4. Set the Myzone control setting.
5. Set the required static pressure setting.
6. Cycle the power to the A/C unit.
7. Connect a 2 core, twisted pair control cable from the C225
(Myzone CPU) to CN1 in the fan coil unit. (A connector
and short cable will need to be provided by the AC unit
manufacturer. Polarity is critical see Fig (i) and (j) on page 32
for correct connection.
7. Unit make:
8. Braemar (SDHV series
inverter ducted, single
phase units only)
9. Gree (GFH inverter
ducted, single phase
units only)
Myzone Wiring
Connections to
Braemar and
Gree Units