Product Reference Guide 5
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are pres-
ent and undamaged. If any damage occurred during shipment, contact Dat-
alogic Technical Support. Information is shown on page 2.
KEEP THE PACKAGING. Should the unit ever require service, it
should be
returned in its original shipping container.
Setting Up the Reader
Follow the steps provided in this section to connect and get your reader up
and communicating with its host.
1. Begin by connecting the scan module to the host. The correct Interface
Sel
ection will occur automatically.
2. If modifications are needed, go to Interface Selection and set the desired
interface.
3. Configure Interface Settings (only if not using factory settings for that
interface)
4. Go to Configuring Other Features (if modifications are needed from fac-
tory settings)
To Next Page
Loading...
Need help?
General